Chrysler 200: Adding Washer Fluid
The fluid reservoir for the windshield washers is located in the engine compartment. Be sure to check the fluid level in the reservoir at regular intervals. Fill the reservoir with windshield washer solvent (not radiator antifreeze) and operate the system for a few seconds to flush out the residual water.
WARNING!
Commercially available windshield washer solvents
are flammable. They could ignite and burn you. Care
must be exercised when filling or working around
the washer solution.
Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the windshield periodically with a sponge or soft cloth and a mild non-abrasive cleaner or use the washer solvent. This will remove accumulations o ...Exhaust System
The best protection against carbon monoxide entry into the vehicle body is a properly maintained engine exhaust system. If you notice a change in the sound of the exhaust system; or if the exha ...See also:
Anti-entrapment function
When the moonroof senses a substantial enough object trapped between its glass
and the vehicle’s roof during closure, it automatically moves back to the fully
open position and stops there. The ...
Instrument Panel Illumination Control
The brightness of the instrument panel lighting and steering wheel controls can be adjusted.
:
Move and hold the thumbwheel up or down to brighten or dim the lights. ...
Carrying Cargo in the Trunk
Distribute cargo evenly on the
floor of the trunk, placing the
heaviest items on the bottom and
as far forward as possible.
If you fold down the back seat, tie
down items that could be thrown ...