Subaru Legacy: Category selection
To activate the category search mode, press the “PTY/CAT” button. To deactivate the category search mode, press the “PTY/CAT” button again.
When in the category search mode, pressing the “FOLDER” button “” changes the category up by one step. Pressing “” changes the category down by one step.
When a category is selected, pressing the “SEEK” button selects channels only within the selected category.
The control function returns to the normal mode after approximately 10 seconds.
Skip channel selection
When in the SAT mode, press the “SEEK” button “” or “” continuously to change to the channel selection mode. Pressing the “SEEK” button “” changes the channel up by 10 step ...Channel scan
If you press the “SCAN” button while the radio is in the category search mode, the radio turns to the category SCAN mode. In the category SCAN mode, the radio scans only channels in the sele ...See also:
Brake fluid level
If you notice that the brake fluid level in
the brake fluid reservoir has fallen to the
MIN mark or less, check the brake system
immediately for leaks. Also check the
thickness of the brake li ...
Fault tracing and actions
If the message Windscreen Sensors blocked is displayed, this means that the camera
is obscured and cannot detect pedestrians, vehicles or road marker lines in front
of the vehicle.
This, in turn, ...
How To Engage The Automatic Locking Mode
1. Buckle the combination lap and shoulder belt.
2. Grasp the shoulder portion and pull downward until
the entire belt is extracted.
3. Allow the belt to retract. As the belt retracts, you will
...