Subaru Legacy: Checking the fluid level - Brake fluid - Maintenance and service - Subaru Legacy Owners ManualSubaru Legacy: Checking the fluid level

WARNING

● Never let brake fluid contact your eyes because brake fluid can be harmful to your eyes. If brake fluid gets in your eyes, immediately flush them thoroughly with clean water. For safety, when performing this work, wearing eye protection is advisable.

● Brake fluid absorbs moisture from the air. Any absorbed moisture can cause a dangerous loss of braking performance.

● If the vehicle requires frequent refilling, there may be a leak. If you suspect a problem, have the vehicle checked at your SUBARU dealer.

CAUTION

● When adding brake fluid, be careful not to allow any dirt into the reservoir.

● Never splash the brake fluid over painted surfaces or rubber parts. Alcohol contained in the brake fluid may damage them.

● Be careful not to spill brake fluid when adding it. If brake fluid touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If brake fluid gets on the exhaust pipe, be sure to wipe it off.

Check the fluid level monthly.

1) “MAX” level mark

1) “MAX” level mark
2) “MIN” level mark

Check the fluid level on the outside of the reservoir. If the level is below “MIN”, add the recommended brake fluid to “MAX”. Use only brake fluid from a sealed container.

    Recommended brake fluid
    CAUTION Never use different brands of brake fluid together. Also, avoid mixing DOT 3 and DOT 4 brake fluids even if they are the same brand. ...

    See also:

    Towing a vehicle with both axles on the ground
    When having your vehicle towed, observe the important safety notes WARNING The power assistance for the steering and the brake force booster do not work when the engine is not running. You ...

    Rear seat armrest
    Activity console Installing the activity console 1. Remove the centre seat cusion. 2. Install the activity console. Removing the activity console 1. Pull the handle and remove the activitycon ...

    Cleaning
    If your windshield is not clear after using the windshield washer or if a wiper blade chatters when running, wax or other material may be on the blade or windshield. Clean the outside of the winds ...