Nissan Altima: Choosing a language
You can interact with the Bluetooth Hands-Free Phone System using English, Spanish or French. To change the language, perform the following.
1. Press and hold the button for more than 5 seconds.
2. The system announces: “Press the PHONE/SEND ( ) button for the hands-free phone system to enter the speaker adaptation mode or press the PHONE/END ( ) button to select a different language.”
3. Press the button. For information on speaker adaptation, see “Speaker Adaptation (SA) mode”in this section.
4. The system announces the current language and gives you the option to change the language to Spanish (in Spanish) or French (in French). To select the current language, press the PHONE/SEND ( ) button. To select a different language, tilt the tuning switch ( or ) up or down.
NOTE:
You must press the button within 5 seconds to change the language.
5. If you decide not to change the language, do not press either button. After 5 seconds, the VR session will end, and the language will not be changed.
Getting started
The following procedures will help you get started using the Bluetooth Hands-Free Phone System with NISSAN Voice Recognition. For additional command options, refer to “List of voice commands” ...Connecting procedure
NOTE: The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled. 1. Press the button on the ...See also:
Parking Tips
Make sure the moonroof (if
equipped) and the windows are
closed.
Turn off the lights.
Place any packages, valuables, etc.,
in the trunk or take them with you.
Lock the doors.
Check the indic ...
Changing the set speed
After a speed has been set, it can be increased or decreased by using the
or
buttons. Each time one of these buttons
is pressed, the vehicle's speed changes by 5 mph (approximately 8 km/h).
...
List Button (Disc Mode For MP3/WMA Play)
Pressing the LIST button will bring up a list of all folders
on the disc. Scrolling up or down the list is done by
turning the TUNE/SCROLL control knob. Selecting a
folder by pressing the TUNE/S ...