Subaru Legacy: Compass calibration
1. If a “C” is displayed in the compass window, the compass needs to be calibrated.
2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads
a direction.
3. Your can also calibrate the compass by driving your vehicle on your everyday
routine. The compass will be calibrated once it has tracked a complete circle.
4. To recalibrate your compass, push and hold the compass display button for 9 seconds
until a “C” appears in the compass window.
5. Calibrate the compass according to step 2 or step 3.
Compass zone adjustment
Compass calibration zones 1. Refer to the “Compass calibration zones” map shown above to verify that the compass zone setting is correct for your geographical location. 2. Press and hold the ...HomeLink® Wireless Control System
The HomeLink® Wireless Control System can be used to activate remote control devices such as gate operators, garage door openers, door locks, home lighting and security systems. There are three ...See also:
Power steering fluid
Check the level frequently. The fluid does not require changing. The fluid level
must be between the MIN and MAX marks. For capacities and recommended fluid grade,
see page 341.
WARNING
I ...
Front passenger’s frontal airbag ON and OFF indicators
The front passenger’s frontal airbag ON and OFF indicators show you the status
of the front passenger’s SRS frontal airbag. The indicators are located next to
the clock in the center porti ...
Engine oil
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes ...