Dodge Avenger: Engine block heater — if equipped
The engine block heater warms the engine, and permitsquicker starts in cold weather. Connect the cord to astandard 110-115 Volt AC electrical outlet with agrounded, three-wire extension cord.
The engine block heater cord is bundled under the hoodbetween the headlight assembly and the Totally IntegratedPower Module (Fuse Box) on the driver’s side ofthe vehicle.
WARNING:
Remember to disconnect the cord before driving.
Damage to the 110-115 Volt electrical cord could causeelectrocution.
Starting procedures
Before starting your vehicle, adjust your seat, adjust theinside and outside mirrors, fasten your seat belt, and ifpresent, instruct all other occupants to buckle their seatbelts. WARNING: Never ...Automatic transmission
CAUTION: Damage to the transmission may occur if the followingprecautions are not observed: • Shift into PARK only after the vehicle has come toa complete stop. • Shift into or out of REVERSE o ...See also:
Adjustment
Adjust the head restraint so the center is level
with the center of the seat occupant’s ears.
To raise the head restraint, pull it up.
To lower, push and hold the lock knob and push
the he ...
List Paired Mobile Phone Names
• Press the button to begin.
• After the “Ready” prompt and the following beep, say
“Setup Phone Pairing”.
• When prompted, say “List Phones”.
• The Uconnect™ Phone will pl ...
Engine compartment
CAUTION
Never use a fuse of a higher or lower
amperage rating than specified on the
fuse box cover. This could damage the
electrical system or cause a fire.
If any electrical equipment does not ...