Subaru Legacy: Front position light - Replacing bulbs - Maintenance and service - Subaru Legacy Owners ManualSubaru Legacy: Front position light

1. Turn the socket counterclockwise and pull it out.

1. Turn the socket counterclockwise and pull it out.

2. Pull out the bulb from the socket and replace the bulb with a new one.

    Front turn signal light
    NOTE It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary. 1. Turn over the protective cover of the engine compartment. 2 ...

    Front fog light (if equipped)
    NOTE It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary. 1. Pull off the fender lining. Refer to “Pulling off the fender l ...

    See also:

    Wiper blades
    Blade inspection NOTICE: Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean. Contamination of either the windshield or the wiper blad ...

    Front power seat adjustment
     FRONT POWER SEAT ADJUSTMENT Operating tips - The power seat motor has an auto-reset overload protection circuit. If the motor stops during operation, wait 30 seconds, then reactivate the ...

    Starting the engine
    The engine starts automatically under the following conditions: ▷ Manual transmission: The clutch pedal is pressed. ▷ Automatic transmission: By releasing the brake pedal. When Auto ...