Subaru Legacy: Hill Holder indicator light - Warning and indicator lights - Instruments and controls - Subaru Legacy Owners ManualSubaru Legacy: Hill Holder indicator light

WARNING

WARNING

If the Hill Holder indicator light does not illuminate even when the Hill Holder switch is pressed to activate the Hill Holder function, the electronic parking brake system may be malfunctioning. Immediately stop the vehicle in a safe location and contact your SUBARU dealer.

The light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds.

The light illuminates when the Hill Holder switch is pressed to activate the Hill Holder function.

    Electronic parking brake system warning
    The brake system warning light flashes when the electronic parking brake system is malfunctioning. If the warning light flashes, promptly park in a safe location as soon as possible and contact yo ...

    Low fuel warning light
    The low fuel warning light illuminates when the tank is nearly empty approximately 2.6 US gal (10.0 liters, or 2.2 Imp gal). It only operates when the ignition switch is in the “ON” position ...

    See also:

    FM selection
    Press the “FM” button when the radio is on to select FM1, FM2 or FM3 reception. Each brief press of the “FM” button changes the radio in the following sequence starting from the last FM r ...

    Engine compartment
    CAUTION Never use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or cause a fire. If any electrical equipment does not ...

    General notes
    The HOLD function can assist the driver in the following situations:  - when pulling away, especially on steep slopes  - when maneuvering on steep slopes  - when waiting in ...