Subaru Legacy: Initialization of power window
If the vehicle’s battery is disconnected due to situations such as battery or fuse replacement, the following functions are deactivated.
● One-touch auto up/down function
● Anti-entrapment function
Initialize the power window in the following procedure to reactivate such functions.
1. Close the driver’s door.
2. Turn the ignition switch to the “ON” position.
3. Open the driver’s side window halfway by pushing down the power window switch.
4. Pull up the power window switch and close the window completely. Continue pulling
up the switch for approximately 1 second after the window is closed completely.
Operating the windows
To open: Press the switch down and hold it until the window reaches the desired position. To close: Pull the switch up and hold it until the window reaches the desired position. When the lock s ...Trunk lid (Legacy)
WARNING ● To prevent dangerous exhaust gas from entering the vehicle, always keep the trunk lid closed while driving. ● Help prevent children, adults or animals from locking themselves ...See also:
Selecting and scanning a folder
■ Selecting a folder
Press or
to select the desired folder.
■ Returning to the first file of the first folder
Press and hold until you hear a
beep.
■ Scanning the first fil ...
Components
1) Front sub sensor (right-hand side)
2) Front sub sensor (left-hand side)
3) SRS airbag system warning light
4) Frontal airbag module (driver’s side)
5) Front passenger’s frontal airbag O ...
Off button
To change the display brightness, press the
OFF button. Pressing the button again
will change the display to the day or
the night display. The brightness can
then be adjusted using the NISSAN c ...