Toyota Camry: Installing the spare tire
Remove any dirt or foreign matter from the wheel contact surface.
If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to come off.
- Install the tire and loosely tighten each wheel nut by hand by approximately the same amount.
When replacing a steel wheel with a steel wheel, tighten the wheel nuts until the tapered portion comes into loose contact with the disc wheel seat.
When replacing an aluminum wheel with a steel wheel, tighten the wheel nuts until the tapered portion comes into loose contact with the disc wheel seat.
Lower the vehicle.
Firmly tighten each wheel nut two or three times in the order shown in the illustration.
Tightening torque:
76 ft•lbf (103 N•m, 10.5 kgf•m)
5. Stow the flat tire, tire jack and all tools.
Replacing a flat tire
Chock the tires. For vehicles with steel wheels, remove the wheel ornament using the wrench. To protect the wheel ornament, place a rag between the wrench and the wheel ornament, as ...The compact spare tire
●The compact spare tire is identified by the label “TEMPORARY USE ONLY” on the tire sidewall. Use the compact spare tire temporarily, and only in an emergency. ●Make sure to check ...See also:
Playing Discs (Models without navigation system)
Playing Discs (Models without navigation system) ...
Oil Check
Wait a few minutes after turning the
engine off before you check the oil.
1. Remove the dipstick (orange
handle/loop).
2. Wipe off the dipstick with a clean
cloth or paper towel.
3. Inser ...
Starting the Engine
With advanced key
Refer to “Starting the engine” for information on how to start the engine.
NOTE:
Engine-starting is controlled by the spark ignition system.
This system meets all Canadian In ...