Nissan Maxima: Interior light
The interior light has a three-position switch and operates regardless of ignition switch position.
- When the switch is in the ON position (1) , the front and rear personal lights will illuminate, regardless of door position. The light will go off after 30 minutes unless the ignition switch is placed in the ON position.
- When the switch is in the center DOOR position (2)- , the front and rear personal lights will illuminate under the following conditions:
Drivers door is unlocked while the ignition switch is placed in the OFF position.
Lights remain on for a maximum of 30 seconds.
Drivers door is opened.
Lights remain on for a maximum of 30 seconds after drivers door is closed.
Ignition switch is placed in the OFF position.
Lights remain on for a maximum of 30 seconds.
The lights will go off when the ignition switch is in theONposition, or the drivers door is closed and locked.
The lights will also go off after 30 minutes when doors are open.
- When the switch is in the OFF position (3)- , the front and rear personal lights will not illuminate, regardless of door position.
NOTE:
The footwell and doorstep lights illuminate when the driver and passenger doors are opened regardless of the interior light switch position. These lights will turn off automatically after 30 minutes while doors are open to prevent the battery from becoming discharged.
CAUTION:
Do not use for extended periods of time with the engine stopped. This could result in a discharged battery.
Rear power sun shade (if so equipped)
The rear sun shade operates when the ignition switch is in the ACC or ON position.
The rear sun shade switch is located on the front console.
- To raise the sun shade, push the upper side of the s ...
Console light
The console light (1) will turn on whenever the parking lights or headlights
are illuminated.
The console light brightness can be adjusted with the illumination brightness
control. ...
See also:
Electrical system
General information
12 volt system with a voltage-regulated alternator. Single pole system in which
the chassis and engine block are used as conductors. The negative terminal is connected
to the ...
High/low beam change (dimmer)
To change from low beam to high beam, push the turn signal lever forward. When
the headlights are on high beam, the high beam indicator light “”
on the combination meter is also on.
To swit ...
Automatic Transmission Ignition Interlock Systems
These systems prevent the key fob from being removed
unless the shift lever is in PARK. They also prevent
shifting out of PARK unless the ignition switch is in the
ON/RUN position and the brake ...
