Subaru Legacy: Low beam light bulbs
1. Pull off the fender lining. For details, refer to “Pulling off the fender lining” F11- 7.
2. Remove the bulb cover, by turning it counterclockwise.
3. Disconnect the electrical connector.
4. Remove the retainer spring.
5. Replace the bulb, then set the retainer spring securely.
6. Reconnect the electrical connector.
7. Install the bulb cover.
8. After replacing the bulb, reattach the fender lining.
Headlight
CAUTION Halogen headlight bulbs become very hot while in use. If you touch the bulb surface with bare hands or greasy gloves, fingerprints or grease on the bulb surface will develop into hot spot ...High beam light bulbs
1. Remove the air intake duct (right-hand side). For the method to remove the air intake duct, refer to “Removing air intake duct” F11-7. Left-hand side 2. Use a screwdriver to remove the se ...See also:
Reclining Seats
The recliner control is located on the side of the seat. To
recline, lean forward slightly before lifting the lever, then
lean back to the desired position and release the lever.
Lean forward and ...
Replacing Brake System Parts
The braking system on a vehicle is
complex. Its many parts have to be
of top quality and work well together
if the vehicle is to have really good
braking. The vehicle was designed
and tested ...
Defogging the windshield
Press .
If the recirculated air mode is
used, it will automatically switch
to the outside air mode.
Perform the following operations
accordingly:
● To adjust the fan speed, turn the ...