Honda Accord: Power Steering Fluid - Maintenance - Honda Accord Owners ManualHonda Accord: Power Steering Fluid

Check the level on the side of the

Check the level on the side of the reservoir when the engine is cold.

The fluid should be between the UPPER LEVEL and LOWER LEVEL.

If not, add power steering fluid to the UPPER LEVEL.

Pour the fluid slowly and carefully

Pour the fluid slowly and carefully so you do not spill any. Clean up any spills immediately; it could damage components in the engine compartment.

Always use Honda Power Steering Fluid. You may use another power steering fluid as an emergency replacement, but have the power steering system flushed and refilled with Honda PSF as soon as possible.

A low power steering fluid level can indicate a leak in the system. Check the fluid level frequently, and have the system inspected as soon as possible.

Turning the steering wheel to f ull lef t

Turning the steering wheel to f ull lef t or right lock and holding it there can damage the power steering pump.

    Clutch Fluid
    Manual transmission only The fluid level should be between theMINandMAXmarks on the side of the reservoir. If it is not, add brake fluid to bring it up to that level. Use the same fluid spec ...

    Timing Belt
    V6 models The timing belt should be replaced according to the Maintenance Minder TM. Replace the timing belt every 60,000 miles (100,000 km) if you regularly drive your vehicle in any of the ...

    See also:

    Vehicle security system activation
    The vehicle security system will give the following alarm: ● The headlights blink and the horn sounds intermittently. ● The alarm automatically turns off after approximately 50 second ...

    Cleaning the sensors
    •► Clean sensors 1 of the driving systems with water, car shampoo and a soft cloth. When cleaning the sensors with a power washer, maintain a distance between the vehicle and the nozz ...

    Turn signals
    1. Remove the headlight housing from the vehicle (see page 306). 2. Remove the cover by pulling it straight out. 3. Pull the holder to access the bulb. 4. Press in the bulb and turn it to remove ...