Subaru Legacy: Preset buttons
How to preset channels
1. Press the “SAT” button to select SAT1, SAT2 and SAT3 reception.
2. Select the desired channel.
3. Press one of the preset buttons for more than 1.5 seconds to store the channel.
If the button is pressed for less than 1.5 seconds, the preceding selection will
remain in memory.
NOTE
If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all channels stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset channels.
Channel preset
...Selecting preset channels
Presetting a channel with a preset button allows you to select that channel in a single operation. Up to six SAT1, SAT2 and SAT3 channels each may be preset. ...See also:
Removing the Flat Tire and
Installing the Spare Tire
1. Do a safety check before
proceeding. See If a Tire Goes
Flat for more
information.
2. Turn the wheel wrench
counterclockwise to loosen the
wheel nut caps.
If needed, finish loosening th ...
Tire Pressure Monitoring Low Pressure Warnings
The “Tire Pressure Monitoring Telltale Light” will
illuminate in the instrument cluster, a LOW TIRE
message will be displayed for a minimum of five
seconds and a chime will sound when tir ...
Seat belt pretensioners
All seat belts are equipped with pretensioners that reduce slack in the belts.
These pretensioners are triggered in situations where the front or side impact airbags
deploy, and in certain impacts ...