Nissan Altima: Removing covers from rear parcel shelf
Remove the top tether anchor cover or key cylinder cover as follows:
1. Lift the cover to the full open position.
2. Rotate the cover in the direction shown, disengaging the hinge at 1 and slide the second pin from the hinge 2 and remove the cover.
Upper tether anchor/key cylinder covers
CAUTION Never force the covers into place because the hinge pins can be damaged. Follow the removal and installation instructions to prevent inoperability of the covers. ...Installing covers to rear parcel shelf
CAUTION Make sure that the hinge is completely aligned with the pin. If the pin is forced into position, it may break. Install the top tether anchor cover or key cylinder cover as follows: 1. ...See also:
Drive belts
It is unnecessary to check the deflection of the drive belt periodically because
your engine is equipped with an automatic belt tension adjuster. However, replacement
of the belt should be done ac ...
AT OIL TEMP warning light (AT and CVT models)
The AT oil temperature warning light “AT OIL TEMP” illuminates when the ignition
switch is turned to the “ON” position and turns off after approximately 2 seconds.
If this light illuminate ...
Tachometer
The red band in the tachometer indicates the
engine's overrevving range.
! Do not drive in the overrevving range, as
this could damage the engine.
The fuel supply is interrupted to protect the
...