Honda Accord: Replacing a Fog Light Bulb - Lights - Maintenance - Honda Accord Owners ManualHonda Accord: Replacing a Fog Light Bulb

If equipped

Your vehicle uses halogen light bulbs. When replacing a bulb, handle it by its plastic case, and protect the glass from contact with your skin or hard objects. If you touch the glass, clean it with denatured alcohol and a clean cloth.

Halogen light bulbs get very hot when

Halogen light bulbs get very hot when lit. Oil, perspiration, or a scratch on the glass can cause the bulb to overheat and shatter.

The fog lights were properly aimed when your vehicle was new. If you regularly carry heavy items in the trunk or pull a trailer, readjustment may be required. Adjustment should be done by your dealer or another qualified technician.

1. Passenger’s side

1. Passenger’s side

Remove the three holding clips with a flat-tip screwdriver.

Pull down the under cover from the bumper carefully.

2. Remove the electrical connector

2. Remove the electrical connector from the bulb by pushing on the tab to unlock it, then slide the connector off the bulb.

3. Remove the bulb by turning it about one-quarter turn counterclockwise.

4. Driver’s side

4. Driver’s side

To change the bulb, start the engine, turn the steering wheel all the way to the right, then turn off the engine.

5. Use a flat-tip screwdriver to remove the two holding clips from the inner fender, and pull the inner fender cover back.

6. Remove the electrical connector

6. Remove the electrical connector from the bulb by pushing on the tab and pulling the connector down.

7. Remove the bulb from the fog light assembly by turning it onequarter turn counterclockwise.

8. Insert the new bulb into the hole, and turn it one-quarter turn clockwise to lock it in place.

9. Push the electrical connector back onto the bulb. Make sure it is on all the way.

10. Turn on the fog lights to test the new bulb.

11. Passenger’s side

Reinstall the under cover and put the holding clips back in place.

Driver’s side

Reinstall the inner fender. Make sure it is installed under the edge of the front bumper.

Reinstall the holding clips, and push in the head of each clip.

    Replacing the High-mount Brake Light Bulb
    1. Open the trunk, and remove the socket from the light assembly by turning it one-quarter turn counterclockwise. 2. Pull the bulb straight out of its socket. Push the new bulb straight int ...

    Rear License Plate Light Bulbs
    The license plate has two lights above it. The bulbs should be replaced by your dealer. ...

    See also:

    Low fuel warning light
    The low fuel warning light illuminates when the fuel tank is nearly empty. It only operates when the ignition switch is in the “ON” position. When this light illuminates, fill the fuel tank im ...

    Outside temperature display
    The temperature display shows temperatures within the range of -40°F (-40°C) and 122°F (50°C). Type A Type B ■The outside temperature is displayed when Vehicles without a smart key ...

    Heated Seats
    Heated Front Seats The buttons are on the climate control panel. To operate, the ignition must be on. Press to heat the driver or passenger seat cushion and seatback. Indicator lights on the clim ...