Toyota Camry: Safety Connect LED light Indicators
When the “ENGINE START STOP” switch is turned to IGNITION ON mode (vehicles with a smart key system) or the engine switch is turned to the “ON” position (vehicles without a smart key system), the red indicator light comes on for 2 seconds then turns off. Afterward, the green indicator light comes on, indicating that the service is active.
The following indicator light patterns indicate specific system usage
conditions:
● Green indicator light on = Active service
● Green indicator light flashing = Safety Connect call in process
● Red indicator light (except at vehicle start-up) = System malfunction
(contact your Toyota dealer)
● No indicator light (off) = Safety Connect service not active
When contacting the response center
You may be unable to contact the response center if the network is busy. ...Safety Connect services
■ Automatic Collision Notification In case of either airbag deployment or severe rear-end collision, the system is designed to automatically call the response center. The responding agent re ...See also:
Spotlights
Turn on a spotlight by pushing the
lens. Push the lens again to turn it
off. You can use the spotlights at all
times.
Except LX
The spotlights have a two-position
switch. In the DOOR pos ...
Reporting safety defects (USA)
If you believe that your vehicle has a defect which could cause a crash or could
cause injury or death, you should immediately inform the National Highway Traffic
Safety Administration (NHTSA) in ...
Compass Messages
CAL
This message is displayed when the compass needs to be calibrated.
See Compass .
– – – Three dashes will be displayed if the compass needs service. See your dealer for service. ...