Chrysler 200: Selection Of Coolant - Cooling System - Maintenance Procedures - Maintaining your vehicle - Chrysler 200 Owners ManualChrysler 200: Selection Of Coolant

Use only the manufacturer’s recommended coolant. Refer to “Fluids, Lubricants, and Genuine Parts” in “Maintaining Your Vehicle” for further information.

CAUTION!
• Mixing of engine coolant (antifreeze) other than specified HOAT engine coolant (antifreeze), may result in engine damage and may decrease corrosion protection. If a non-HOAT engine coolant (antifreeze) is introduced into the cooling system in an emergency, it should be replaced with the specified engine coolant (antifreeze) as soon as possible.

• Do not use water alone or alcohol-based engine coolant (antifreeze) products. Do not use additional rust inhibitors or antirust products, as they may not be compatible with the engine coolant (antifreeze) and may plug the radiator.

• This vehicle has not been designed for use with Propylene Glycol based engine coolant (antifreeze).

Use of Propylene Glycol based engine coolant (antifreeze) is not recommended.

    Cooling System – Drain, Flush, And Refill
    If the engine coolant (antifreeze) is dirty or contains a considerable amount of sediment, clean and flush with a reliable cooling system cleaner. Follow with a thorough rinsing to remove all de ...

    Adding Coolant
    Your vehicle has been built with an improved engine coolant (antifreeze) that allows extended maintenance intervals. This engine coolant (antifreeze) can be used up to five years or 104,000 mile ...

    See also:

    Rear seats
    WARNINGS: Make sure that the seats and theseatbacks are secure and fullyengaged in their catches. When folding the seatbacks down,take care not to get your fingerscaught between the seatback andseat ...

    Aux, USB and iPod® port (if equipped)
    If your vehicle has an aux and/or USB(universal serial bus) port or iPod port, you can use an aux port to connect audio devices and a USB port to plug in a USB, and an iPod port to plug in an iPod ...

    Wipe Parking
    If the ignition is turned to LOCK/OFF while the wipers are on 1, 2, or , they will immediately stop. If the windshield wiper lever is then moved to before the driver door is opened, or within ...