Subaru Legacy: START - Ignition switch - Instruments and controls - Subaru Legacy Owners ManualSubaru Legacy: START

CAUTION

Do not turn the ignition switch to the “START” position while the engine is running.

The engine is started in this position. The starter cranks the engine to start it. When the key is released (after the engine has started), the key automatically returns to the “ON” position.

If the engine does not start with your registered key, pull out the key once (at this time, the security indicator light will blink), wait for at least 10 seconds, reinsert the key in the ignition switch and then try to start the engine again.

NOTE

The engine may not start in the following cases:

● The key grip is touching another key or a metallic key holder.

● The key grip is touching another key or a metallic key holder.

● The key is near another key that contains an immobilizer transponder.

● The key is near another key that contains an immobilizer transponder.

● The key is near or touching another transmitter.

    ON
    This is the normal operating position after the engine is started. ...

    Key reminder chime
    The reminder chime sounds when the driver’s door opens and the key is in the “LOCK” or “Acc” positions. The chime stops when the ignition switch is turned to the “ON” position or the ...

    See also:

    Stereo indicator
    The stereo indicator “ST” will illuminate when an FM stereo broadcast is received. ...

    Lane Keeping Assist
    Important safety notes Lane Keeping Assist monitors the area in front of your vehicle by means of a camera at the top of the windshield. Lane Keeping Assist detects lane markings on the road an ...

    Key replacement
    Your key number plate and security ID plate will be required if you ever need a replacement key made. Any new key must be registered for use with your vehicle’s immobilizer system before it can ...