Mercedes-Benz E-Class: Tire pressure of at least 180 kPa (1.8 bar/26 psi) is not reached
If, after five minutes, a pressure of 180 kPa (1.8 bar/26 psi) has not been achieved:
•► Press the on/off switch on the tire inflation compressor to 0.
The tire inflation compressor is switched off.
•► Unscrew the filler hose from the valve of the faulty tire.
•► Very slowly drive forwards or reverse approximately 30 ft (10 m).
•► Pump up the tire again.
WARNING
If after five minutes a pressure of 180 kPa
(1.8 bar/26 psi) cannot be achieved, the tire
is too badly damaged to be repaired reliably
using TIREFIT.
In this case TIREFIT cannot seal the tire properly.
Do not drive any further.
Contact the nearest authorized Mercedes- Benz Center for assistance or call Roadside Assistance.
Using the TIREFIT kit
You can use the TIREFIT kit to seal small punctures, particularly those in the tire tread. You can use TIREFIT at outside temperatures down to -4 °F (-20 °C). WARNING TIREFIT is a limite ...Tire pressure of 180 kPa (1.8 bar/ 26 psi) is reached
•► Press the on/off switch on the tire inflation compressor to 0. The tire inflation compressor is switched off. •► Unscrew the filler hose from the valve of the faulty tire. ...See also:
Replacement of brake pad and lining
CAUTION
If you continue to drive despite the scraping noise from the audible brake pad
wear indicator, it will result in the need for costly brake rotor repair or replacement.
The right front di ...
Precautions on supplemental restraint system
This Supplemental Restraint System (SRS) section
contains important information concerning
the following systems:
● Driver and passenger supplemental frontimpact
air bag (NISSAN Advanced Air ...
To prevent battery discharge
Vehicles without a smart key system:
HomeLink® will turn off if a door has not been opened and closed for 20 minutes
or the engine switch is left turned off. (After which programming cannot
be c ...