Subaru Legacy: To set cruise control
1. Press the “CRUISE” main switch button.
The cruise control indicator light on the combination meter will illuminate.
2. Depress the accelerator pedal until the vehicle reaches the desired speed.
3. Press the “RES/SET” switch to the “SET” side and release it. Then release the accelerator pedal.
At this time, the cruise control set indicator light is illuminated in the combination meter.
The vehicle will maintain the desired speed.
Vehicle speed can be temporarily increased while driving with the cruise control activated. Simply depress the accelerator pedal to accelerate the vehicle. When the accelerator pedal is released, the vehicle will return to and maintain the previous cruising speed.
Cruise control
Cruise control enables you to maintain a constant vehicle speed without holding your foot on the accelerator pedal and it is operative when the vehicle speed is 25 mph (40 km/h) or more. WARNING ...To temporarily cancel the cruise control
The cruise control can be temporarily canceled in the following ways. ● Press the “CANCEL” button. ● Depress the brake pedal. ● Depress the clutch pedal (MT models only). & ...See also:
Engine compartment check locations
QR25DE engine
1. Power steering fluid reservoir (P. 8-14)
2. Engine oil filler cap (P. 8-10)
3. Brake fluid reservoir/Clutch fluid
reservoir (M/T model) (P. 8-15, 8-15)
4. Air cleaner (P. 8-20) ...
Alternate Command Mode command list
Phone Command:
Navigation Command:
Information Command:
Audio Command:
...
Electronic speed control
When engaged, the Electronic Speed Control takes overthe accelerator operation
at speeds greater than 25 mph(40 km/h).
The Electronic Speed Control lever is located on the rightside of the steering ...