Subaru Legacy: Windshield wipers
MIST : Mist (for a single wipe)
OFF : Off
INT: Intermittent
LO: Low speed
HI: High speed
To turn the wipers on, push the wiper control lever down.
To turn the wipers off, return the lever to the “OFF” position.
For a single wipe of the wipers, push the lever up. The wipers operate until you release the lever.
Windshield wiper and washer switches
The wiper operates only when the ignition switch is in the “ON” position. ...Wiper intermittent time control
When the wiper switch is in the “INT” position, turn the dial to adjust the operating interval of the wiper. The operating interval can be adjusted in five steps from the shortest interval t ...See also:
SRS airbag system monitors
A diagnostic system continually monitors the readiness of the SRS airbag system
(including front seatbelt pretensioners) while the vehicle is being driven. The
SRS airbag system warning light wi ...
Important safety notes
You will find an illustration of the instrument
cluster in the "At a glance" section
WARNING
A driver's attention to the road and traffic
conditions must always be his/her primary ...
Replacing components
Vehicle equipment
All standard, country-specific and optional
equipment that is offered in the model series is
described in this chapter. Therefore, equipment
is also described that is not avai ...