Subaru Legacy: Defrosting or defogging
To direct warm air to the windshield and front door windows:
1. Press the “” button.
2. Set the temperature control dial to the red side.
3. Set the fan speed control dial at the highest speed.
NOTE
When the “” button or “” button is pressed the air conditioner compressor automatically operates to quickly defog the windshield. However the indicator on the air conditioner button will not illuminate. At the same time, the air inlet selection is automatically set to “outside air” mode.
Cooling or dehumidifying
For cooling and dehumidification of the passenger compartment, air flows through the instrument panel outlets: 1. Set the air inlet selection button to the OFF position. 2. Press the “” button ...Automatic climate control system (if equipped)
NOTE ● Operate the automatic climate control system when the engine is running. ● The blower fan rotates at a low speed when the engine coolant temperature is low. For efficient defog ...See also:
Problems with fuel and the fuel tank
Problem
Possible causes/consequences and - Solutions
Fuel is leaking from the
vehicle.
!!! Risk of explosion or fire !!!
The fuel line or the fuel tank is defective.• ...
Programming Additional Transmitters
Refer to Sentry Key “Customer Key Programming.”
If you do not have a programmed RKE transmitter,
contact your authorized dealer for details. ...
30,000 miles (48,000 km) or 24 months
❑ Inspect vacuum hose
❑ Inspect air conditioning refrigerant
❑ Inspect brake hoses and lines
❑ Inspect drive shafts and boots
❑ Inspect electronic throttle contr ...