Subaru Legacy: Turn signal indicator lights - Warning and indicator lights - Instruments and controls - Subaru Legacy Owners ManualSubaru Legacy: Turn signal indicator lights

These lights show the operation of the turn signal or lane change signal.

These lights show the operation of the turn signal or lane change signal.

If the indicator lights do not blink or blink rapidly, the turn signal bulb may be burned out. Replace the bulb as soon as possible. Refer to “Replacing bulbs” F11-48.

    Gear position indicator setting (MT models)
    The gear position indicator light can be activated or deactivated by performing the following procedure. 1. Turn the ignition switch to the “LOCK” position. 2. Press the trip knob to show “ ...

    High beam indicator light
    This light shows that the headlights are in the high beam mode. This indicator light also illuminates when the headlight flasher is operated. ...

    See also:

    AM radio reception
    AM signals, because of their low frequency, can bend around objects and skip along the ground. In addition, the signals can be bounced off the ionosphere and bent back to earth. Because of these ...

    Storage pouch (if so equipped)
    A storage pouch is located on the front of the driver’s and passenger’s seats. WARNING Do not store angular, sharp, heavy objects or objects that cannot fully fit inside the pouch because t ...

    Trunk Release
    To open the trunk, press on the Remote Keyless Entry (RKE) transmitter or press the touchpad under the vehicle emblem. See Trunk  for additional information. ...