Subaru Legacy: Vehicle Dynamics Control operation indicator light
The indicator light flashes during activation of the skid suppression function and during activation of the traction control function.
NOTE
● The light may remain illuminated for a short period of time after the engine
has been started, especially in cold weather. This does not indicate the existence
of a problem. The light should turn off as soon as the engine has warmed up.
● The indicator light illuminates when the engine has developed a problem and the
CHECK ENGINE warning light/ malfunction indicator lamp is on. The Vehicle Dynamics
Control system is probably malfunctioning under the following condition. Have your
vehicle checked at a SUBARU dealer as soon as possible.
● The light does not turn off even after the lapse of several minutes (the engine
has warmed up) after the engine has started.
Vehicle Dynamics Control warning light
CAUTION The Vehicle Dynamics Control system provides its ABS control through the electrical circuit of the ABS system. Accordingly, if the ABS is inoperative, the Vehicle Dynamics Control system ...Vehicle Dynamics Control OFF indicator light
The light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds. The light illuminates when the Vehicle Dynamics Control OFF switch ...See also:
Cup holder in the front-compartment
center console
You can remove the cup holder to clean it.
Clean with clear, lukewarm water only.
E 63 AMG
•► To open: slide cover 1 back
All vehicles except E 63 AMG
•► To open ...
SERVICE PARKING BRAKE
This message is displayed when
there is a problem with the electric
parking brake. See Parking Brake for more information.
Take the vehicle to your dealer. ...
Trailer load/noseweight
The trailer load/noseweight affects the gross
weight of the vehicle. If a trailer is attached,
the trailer load/noseweight is included in the
load along with occupants and luggage. The
trailer ...