Subaru Legacy: ABS warning light
The ABS warning light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds.
This is an indication that the ABS system is working properly.
CAUTION
● If any of the following conditions occur, we recommend that you have the ABS system repaired at the first available opportunity by your SUBARU dealer.
– The warning light does not illuminate when the ignition switch is turned to
the “ON” position.
– The warning light illuminates when the ignition switch is turned to the “ON” position,
but it does not turn off even when the vehicle speed exceeds approximately 12 km/h
(8 mph).
– The warning light illuminates during driving.
– The warning light flashes.
● When the warning light is on (and brake system warning light is off), the ABS
function shuts down; however, the conventional brake system continues to operate
normally.
● When the warning light is flashing, the ABS system may be malfunctioning. However,
the conventional brake system continues to operate normally.
NOTE
If the warning light behavior is as described in the following, the ABS system
may be considered normal.
● The warning light illuminates right after the engine is started but turns off
immediately, remaining off.
● The warning light remains illuminated after the engine has been started, but it
turns off when the vehicle speed reaches approximately 8 mph (12 km/h).
● The warning light illuminates during driving, but it turns off immediately and
remains off.
When driving with an insufficient battery voltage such as when the engine is jump
started, the ABS warning light may illuminate. This is due to the low battery voltage
and does not indicate a malfunction. When the battery becomes fully charged, the
light will turn off.
ABS system self-check
You may feel a slight shock in the brake pedal and hear the operating sound of ABS from the engine compartment just after the vehicle is started. This is caused by an automatic functional test of ...Electronic Brake Force Distribution (EBD) system
The EBD system maximizes the effectiveness of the brakes by allowing the rear brakes to supply a greater proportion of the braking force. It functions by adjusting the distribution of braking forc ...See also:
Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
A. Taillamp/Sidemarker Lamp
B. Taillamp
C. Stop/Turn Signal Lamp
D. Back-up Lamp
To replace any one of these bulbs:
1. Open the trunk. See Trunk Release .
2. Remove the taillamp assembly ...
Doing Your Own Service Work
WARNING
You can be injured and the vehicle could be damaged if you try to do service work on a vehicle without knowing enough about it.
► Be sure you have sufficient knowledge, experience, ...
Feature of distance marker
1) 3 feet (1 m) line
2) 6.5 feet (2 m) line
3) 10 feet (3 m) line
The distance marker shows the distance on the road. If there is a car or other
object close behind, distance cannot be correctl ...