Subaru Legacy: Activating and deactivating the alarm system
To change the setting of your vehicle’s alarm system for activation or deactivation, do the following.
1. Disarm the alarm system. Refer to “Disarming the system” F2-18.
2. Sit in the driver’s seat and shut all doors (and the rear gate (Outback)).
3. Turn the ignition switch to the “ON” position.
4. Hold down the REAR (UNLOCK) side of the driver’s power door locking switch, open
the driver’s door within the following 1 second, and wait 10 seconds without releasing
the switch. The setting will then be changed as follows:
If the system was previously activated: The trip meter screen displays “AL oF” and the horn sounds twice, indicating that the system is now deactivated.
If the system was previously deactivated: The trip meter screen displays “AL on” and the horn sounds once, indicating that the system is now activated.
NOTE
You may have the above setting change done by your SUBARU dealer.
System alarm operation
The alarm system will give the following alarms when triggered: ● The vehicle’s horn will sound and the turn signal lights will flash for 30 seconds. ● If any door (or the rear gate/ ...If you have accidentally triggered the alarm system
To stop the alarm Perform any of the following operations. ● Press any button on the remote transmitter. ● Turn the ignition switch to the “ON” position. ...See also:
Driver's door controls
Driver's door controls
Roller blind for rear window
Press the button. ...
Vehicle Dynamic Control
(VDC) OFF indicator light
This indicator light comes on when the Vehicle
Dynamic Control off switch is pushed to OFF.
This indicates the Vehicle Dynamic Control has
been turned off.
Push the Vehicle Dynamic Control off s ...
Visual indicator
The audio system’s display gives an overview of the vehicle’s position in relation
to a detected object.
The marked sectors in the display indicate that one or more of the sensors has
detecte ...