Mercedes-Benz E-Class: Activating/deactivating the residual heat function - Operating the climate control system - Climate control - Mercedes-Benz E-Class Owners ManualMercedes-Benz E-Class: Activating/deactivating the residual heat function

The residual heat function is only available in vehicles for Canada with automatic climate control.

It is possible to make use of the residual heat of the engine to continue heating the stationary vehicle for up to 30 minutes after the engine has been switched off. The heating time depends on the temperature that has been set.

The blower will run at a low speed regardless of the airflow setting.

If you activate the residual heat function at high temperatures, only the ventilation will be activated. The blower runs at medium speed.

It is possible that the residual heat function may be activated automatically an hour after the SmartKey is removed. The vehicle is then ventilated for 30 minutes to dry the air-conditioning system.

•► Turn the SmartKey to position 0 in the ignition lock or remove it.

•► To activate: press the button. button.

The indicator lamp above the lights up. button lights up.

•► To switch off: press the button. button.

The indicator lamp above the goes out. button goes out.

Residual heat is deactivated automatically:

 - after about 30 minutes
 - when the ignition is switched on
 - if the battery voltage drops
 - if the coolant temperature is too low

    Activating/deactivating airrecirculation mode
    You can deactivate the flow of fresh air if unpleasant odors are entering the vehicle from outside. The air already inside the vehicle will then be recirculated. The operation of air-recirculat ...

    See also:

    Control panel buttons ó color screen with Navigation System (if so equipped)
    1. ZOOM OUT button*. 2. STATUS button. 3. DEST button*. 4. ROUTE button*. 5. NISSAN controller. 6. INFO button. 7. PHONE button**. 8. + (brightness control) button. 9. OFF brightness control ...

    Fuses
    A vehicle’s electrical system is protected from electrical overload damage by fuses. This vehicle has 2 fuse panels, one located in the driver’s side panel bolster, the other in the engine ...

    Important safety notes
    WARNING When leaving the vehicle, always remove the SmartKey from the ignition lock. Always take the SmartKey with you and lock the vehicle. Do not leave children unsupervised in the vehic ...