Subaru Legacy: Adjusting the front seat shoulder belt anchor height
The shoulder belt anchor height should be adjusted to the position best suited for the driver/front passenger. Always adjust the anchor height so that the shoulder belt passes over the middle of the shoulder without touching the neck.
To raise:
Slide the anchor up.
To lower:
Push the release button and slide the anchor down.
Pull down the anchor to make sure that it is locked in place.
WARNING
When wearing the seatbelts, make sure the shoulder portion of the webbing does not pass over your neck. If it does, adjust the seatbelt anchor to a lower position. Placing the shoulder belt over the neck may result in neck injury during sudden braking or in a collision.
Front seatbelts
1. Adjust the seat position: Driver’s seat: Adjust the seatback to the upright position. Move the seat as far from the steering wheel as practical while still maintaining full vehicle control. ...Unfastening the front seatbelt
Push the button on the buckle. Before closing the door, make sure that the belts are retracted properly to avoid catching the belt webbing in the door. ...See also:
Windshield Wiper/Washer
The windshield wiper lever is on the side of the steering column.
2: Use for fast wipes.
1: Use for slow wipes.
Turn the band up for more frequent wipes or down for less frequent wipes.
Us ...
Brake System
Foot Brake
Your Mazda has power-assisted brakes that adjust automatically through normal
use.
Should power-assist fail, you can stop by applying greater force than normal
to the brake pedal. But ...
Using the TIREFIT kit
You can use the TIREFIT kit to seal small
punctures, particularly those in the tire tread.
You can use TIREFIT at outside temperatures
down to -4 °F (-20
°C).
WARNING
TIREFIT is a limite ...