Subaru Legacy: All-Wheel Drive warning light (AT and CVT models)
WARNING
Continued driving with the AWD warning light flashing can lead to powertrain damage. If the AWD warning light flashes, promptly park in a safe place then check whether all four tires are the same diameter and whether any of the tires has a puncture or has lost air pressure for some other reason.
The All-Wheel Drive warning light illuminates when the ignition switch is turned to the “ON” position and turns off after the engine has started.
Windshield washer fluid warning light
This light illuminates when the fluid level in the windshield washer fluid tank
decreases to the lower limit (approximately 0.6 US qt, 0.6 liter, 0.5 Imp qt). ...
For AT models
This light flashes if the vehicle is driven with tires of different diameters
fitted on its wheels or with the air pressure excessively low in any of its tires. ...
See also:
Driving on Uneven Road
Your vehicle's suspension and underbody can be damaged if driven on rough/uneven
roads or over speed bumps at excessive speeds. Use care and reduce speed when traveling
on rough/uneven roads o ...
NISSAN Intelligent Key™
Replace the battery in the Intelligent Key as follows:
1. Remove the mechanical key from the Intelligent
Key.
2. Insert a small screwdriver A into the slit B
of the corner and twist it to separa ...
Re-installing the wheel
1. Clean the contact surfaces on the wheel and hub.
2. Lift the wheel and place it on the hub.
Tighten the lug nuts
3. Install the wheel nuts and tighten handtight. Using the lug wrench, tighten ...
