Chrysler 200: Automatic Transmission
The shift lever must be in the PARK or NEUTRAL position before you can start the engine. Apply the brakes before shifting to any driving gear.
NOTE:
The ignition switch must be in the ON position,
and you must press the brake pedal before shifting out of
PARK.
Starting Procedures
Before starting your vehicle, adjust your seat, adjust the inside and outside mirrors, fasten your seat belt, and if present, instruct all other occupants to buckle their seat belts. WARNING! ...Normal Starting
NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal. For vehicles not equipped with Tip Start (Four-Speed Transmission), turn ...See also:
Interior
Adjust this mirror for a clear view of
the area behind the vehicle. Hold
the mirror in the center to move it
up, down, or side to side. To reduce
headlamp glare from behind, push
the tab for ...
Repairing stone chips
1. Place a strip of masking tape over the damaged surface. Pull the tape off
so that any loose flakes of paint adhere to it.
2. Thoroughly mix the primer and apply it with a small brush.
3. When ...
Temperature Control
Rotate this control to regulate the temperature
of the air inside the passenger
compartment. Rotating the dial left
into the blue area of the scale indicates
cooler temperatures, while rotat ...