Chrysler 200: Automatic Transmission
The DRIVE range can be selected when towing. However, if frequent shifting occurs, select the 3 range (for a four-speed automatic) or select a lower gear using the AutoStick shift control.
NOTE:
Using a lower gear while operating the vehicle
under heavy operating conditions, will improve performance
and extend transmission life by reducing excessive
shifting and heat build-up. This action will also
provide better engine braking.
If you REGULARLY TOW a trailer for more than 45 minutes of continuous operation, then change the automatic transmission fluid and filter according to the interval specified for “police, taxi, fleet, or frequent trailer towing.” Refer to the “Maintenance Schedule” for the proper maintenance intervals.
NOTE:
Check the four-speed automatic transmission
fluid level before towing. Six-speed transmissions do not
require a fluid level check before towing. If, however, you
notice fluid leakage or transmission malfunction, see
your authorized dealership service center for assistance.
Towing Tips
Before setting out on a trip, practice turning, stopping, and backing the trailer in an area located away from heavy traffic. Make sure all trailer and vehicle lights are working properly — i ...Electronic Speed Control – If Equipped
• Do not use in hilly terrain or with heavy loads. • When using the speed control, if you experience speed drops greater than 10 mph (16 km/h), disengage until you can get back to cruising sp ...See also:
Control Locations
Control Locations ...
Moisture
Accumulation of sand, dirt and water on the vehicle
body underside can accelerate corrosion.
Wet floor coverings will not dry completely inside
the vehicle and should be removed for drying to
avoi ...
Door locks
Operating door locks from outside the vehicle
• Turn the key toward the rear of the vehicle to unlock and toward the front
of the vehicle to lock.
• If you lock the door with a key, all vehi ...