Subaru Legacy: Battery drainage prevention function - Door locks - Keys and doors - Subaru Legacy Owners ManualSubaru Legacy: Battery drainage prevention function

If a door or the rear gate (Outback) is not completely closed, the interior lights will remain illuminated as a result. However, several lights are automatically turned off by the battery drainage prevention function to prevent the battery from going dead. The following interior lights are affected by this function.

*1: The map lights can be controlled by the battery drainage prevention function

*1: The map lights can be controlled by the battery drainage prevention function only when the map light switches are in the OFF position and the door interlock switch is in the DOOR position. For the switch positions, refer to “Map light” F6-2.

*2: The door step lights are not affected by the battery drainage prevention function, so the lights do not turn off automatically. To turn off the lights, it is necessary that each door is completely closed.

The operational/non-operational setting of this function can be changed by a SUBARU dealer. Contact the nearest SUBARU dealer if you would like to change the setting.

NOTE

● The factory setting (default setting) for this function is set as “operational”.
● When leaving the vehicle, please make sure that all doors and the rear gate (Outback) are completely closed.
● The battery drainage prevention function does not operate while the key is in the ignition switch.

    Locking and unlocking from the inside
    WARNING Keep all doors locked when you drive, especially when small children are in your vehicle. Along with the proper use of seatbelts and child restraints, locking the doors reduces the chanc ...

    Power door locking switches
    1) Lock 2) Unlock All doors and the rear gate (Outback) can be locked and unlocked by the power door locking switches located at the driver’s side and the front passenger’s side doors. To ...

    See also:

    Problems with the engine
    Problem Possible causes/consequences and - Solutions The engine does not start. The starter motor can be heard.  - There is a malfunction in the engine electronics. ...

    Buttons at a glance
    1. System on/off, interrupt 2. Resume speed 3. Store speed 4. Reduce distance 5. Store, maintain/change speed 6. Increase distance ...

    To Select a Station
    You can use any of five methods to find radio stations on the selected band: tune, skip, scan, the preset buttons, and auto select. On the FM band, you can also use the features provided by t ...