Subaru Legacy: Behavior with key lock-in prevention function non-operational
● If the lock lever is turned to the rear (“LOCK”) position with the driver’s door open and the driver’s door is then closed with the lock lever in that position, the driver’s door is locked. . If the spare key is used to lock the driver’s door from the outside of the vehicle, the door is locked. This function’s operational/non-operational setting can be changed by a SUBARU dealer. Contact a SUBARU dealer for details.
NOTE
● The factory setting (default setting) for this function is set as “operational”.
● When leaving the vehicle, make sure you are holding the key before locking the
doors.
Behavior with key lock-in prevention function operational
With the driver’s door open, the doors are automatically kept unlocked even if
the front side of the power door locking switch is pressed. ...
Remote keyless entry system
CAUTION
● Do not expose the remote transmitter to severe shocks, such as those experienced
as a result of dropping or throwing.
● Do not take the remote transmitter apart except when r ...
See also:
Security feature
If a door is not opened within approximately 60 seconds after the vehicle is
unlocked, the security feature automatically locks the vehicle again. (However,
depending on the location of the electr ...
To temporarily cancel the cruise control
The cruise control can be temporarily canceled in the following ways.
● Press the “CANCEL” button.
● Depress the brake pedal.
● Depress the clutch pedal (MT models only).
& ...
Floor mat
Retaining pins are located on the driver’s side floor.
The floor mat is secured using the built-in grommets, by placing the grommets
over the pins and pushing them downward.
CAUTION
Make su ...
