Chrysler 200: Bluetooth Streaming Audio (BTSA)
Music can be streamed from your cellular phone to the Uconnect™ phone system.
Controlling BTSA Using Radio Buttons
To get into the BTSA mode, press either “AUX” button on the radio or press the VR button and say “Bluetooth Streaming Audio”.
Play Mode
When switched to BTSA mode, some audio devices can start playing music over the vehicle’s audio system, but some devices require the music to be initiated on the device first, then it will get streamed to the Uconnect™ phone system. Seven devices can be paired to the Uconnect™ phone system, but just one can be selected and played.
Selecting Different Audio Device
1. Press PHONE button to begin.
2. After the Ready prompt and the following beep, say Setup , then Select Audio Devices .
3. Say the name of the audio device or ask the Uconnect™ phone system to list audio devices.
Next Track
Use the SEEK UP button, or press the VR button on the radio and say “Next Track” to jump to the next track music on your cellular phone.
Previous Track
Use the SEEK DOWN button, or press the VR button on the radio and say “Previous Track” to jump to the previous track music on your cellular phone.
Browse
Browsing is not available on a BTSA device. Only the current song that is playing will display info.
List Or Browse Mode
During Play mode, pressing any of the buttons described below, will bring up List mode. List mode enables scrolling through the list of menus and tracks on the audio device. • TUNE control kn ...Steering Wheel Audio Controls — If Equipped
Remote Sound System Controls (Back View Of Steering Wheel) The remote sound system controls are located on the rear surface of the steering wheel, at the three and nine o’clock positions. Th ...See also:
Status field symbols
The symbols are grouped as follows.
Radio symbols
Telephone symbols
Entertainment symbols
Additional symbols
...
Master warning light
When the ignition is in the ON position, the
master warning light illuminates if any of the following
are displayed on the vehicle information
display.
● No key warning
● Low fuel w ...
Conditions in Which Remote Start
Will Not Work
The remote start will not operate if:
• The key is in the ignition (key
access) or the ignition is in any
position other than OFF (keyless
access).
• The transmitter is in the vehicle
(k ...