Volvo S60: Calibration
The compass may need to be calibrated if, for example, the vehicle is driven into a new magnetic zone. The character C is shown in the mirror's display if calibration is necessary.
1. Stop the vehicle in a large open area, safely out of traffic and away from steel structures and high-tension electrical wires.
2. Start the vehicle.
NOTE
For best results from calibration, switch off all electrical equipment in the vehicle (climate system, windshield wipers, audio system, etc.) and make sure that all doors are closed.
3. Using a pen or similar object, press and hold the button on the underside of mirror until C is shown again in the mirror(after approx. 6 seconds).
4. Drive as usual. C disappears from the display when calibration is complete.
Alternative calibration method:
Drive slowly in a circle at a speed of no more than 5 mph (8 km/h) until C disappears from the display when calibration is complete.
Operation
Rearview mirror with compass.
The rearview mirror has an integrated display that shows the compass direction
in which the vehicle is pointing. Eight different directions are shown with the
abbr ...
Selecting a magnetic zone
Magnetic zones.
The earth is divided into 15 magnetic zones. The correct zone must be selected
for the compass to work correctly.
1. Put the ignition in mode II.
2. Using a pen or similar objec ...
See also:
Recommended grade and viscosity
Each oil manufacturer has its own base oils and additives. Never use different
brands together. For details, refer to “Manual transmission, front differential
and rear differential gear oil” F ...
introduction
You can establish a Bluetooth® connection to
COMAND (see the separate operating
instructions).
WARNING
A driver's attention to the road must always
be his/her primary focus when driving. ...
Switching the display
Press .
Each time is pressed, the display
changes in the following order:
Track no./Elapsed time → Album name → Track title → Artist name. ...
