Subaru Legacy: Cargo area light (Outback) - Replacing bulbs - Maintenance and service - Subaru Legacy Owners ManualSubaru Legacy: Cargo area light (Outback)

1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.

1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.

2. Pull the bulb out of the socket.

2. Pull the bulb out of the socket.

3. Install a new bulb.

4. Reinstall the lens.

    Door step light
    1. Remove the lens by prying the edge of the lens with a flat-head screwdriver. 2. Pull the bulb out of the socket. 3. Install a new bulb. 4. Reinstall the lens. ...

    Trunk light (Legacy)
    1. Push both sides of the light cover, and then remove the cover by pulling it out. 2. Pull the bulb out of the socket. 3. Install a new bulb. 4. Reinstall the cover. ...

    See also:

    Displaying the button assignment
    Use a finger to touch the buttons. Do not wear gloves or use objects. The key assignment is displayed at the top edge of the screen. Displaying the button assignment ▷ To display short ...

    Storing the current speed or calling up the last stored speed
    WARNING The set speed stored in memory should only be set again if prevailing road conditions and legal speed limits permit. Possible acceleration or deceleration differences arising from ...

    Most common factors contributing to vehicle corrosion
    ● The accumulation of moisture-retaining dirt and debris in body panel sections, cavities, and other areas. ● Damage to paint and other protective coatings caused by gravel and stone c ...