Subaru Legacy: Checking the fluid level
WARNING
Never let clutch fluid contact your eyes because clutch fluid can be harmful to your eyes. If clutch fluid gets in your eyes, immediately flush them thoroughly with clean water. For safety, when performing this work, wearing eye protection is advisable.
CAUTION
● Clutch fluid absorbs moisture from the air. Any absorbed moisture can cause improper clutch operation.
● If the vehicle requires frequent refilling, there may be a leak. If you suspect a problem, have the vehicle checked at your SUBARU dealer.
● When clutch fluid is added, be careful not to allow any dirt into the tank.
● Never splash the clutch fluid over painted surfaces or rubber parts. Alcohol contained in the clutch fluid may damage them.
● Be careful not to spill clutch fluid when adding it. If clutch fluid touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If clutch fluid gets on the exhaust pipe, be sure to wipe it off.
1) “MAX” level mark
2) “MIN” level mark
Check the fluid level on the outside of the reservoir. If the level is below “MIN” level mark, add the recommended clutch fluid to “MAX” level mark.
Use only clutch fluid from a sealed container.
Recommended clutch fluid
CAUTION Never use different brands of clutch fluid together. Also, avoid mixing DOT 3 and DOT 4 brake fluids even if they are the same brand. ...See also:
Parking Brake
The vehicle has an Electric Parking Brake (EPB). The switch for the EPB is on the center console.
The EPB can always be activated, even if the ignition is off. To prevent draining the battery, avoi ...
Setting a speed
Once ACC has been put in standby mode, use the
or
buttons to store (set) the vehicle's
current speed. This puts the system in active mode. The set speed, for example 55
mph, is shown in th ...
Switching the door unlock function
It is possible to set which doors the entry function unlocks using the
wireless
remote control.
Turn the “ENGINE START STOP” switch off.
When the indicator light on the key surface is not on ...