Buick LaCrosse: Compass
The vehicle may have a compass display on the Driver Information Center (DIC). The compass receives its heading and other information from the Global Positioning System (GPS) antenna, StabiliTrak, and vehicle speed information.
Avoid covering the GPS antenna for long periods of time with objects that may interfere with the antenna's ability to receive a satellite signal.
See Backglass Antenna and Satellite Radio Antenna for the location of the vehicle's antennas.
The compass system is designed to operate for a certain number of miles or degrees of turn before needing a signal from the GPS satellites. When the compass display shows CAL, drive the vehicle for a short distance in an open area where it can receive a GPS signal. The compass system will automatically determine when the GPS signal is restored and provide a heading again. See Compass Messages for more information on the messages that may be displayed for the compass.
Windshield Washer
Pull the windshield wiper lever
toward you to spray windshield
washer fluid and activate the wipers.
The washer and wipers will continue
until the lever is released or the
maximum wash time i ...
Clock (Radio with CD and Touchscreen)
The infotainment system controls
are used to access the time and
date settings through the menu
system. See Overview (Radio with
CD) or Overview
(Radio with CD/DVD and MEM) or Overview (Radi ...
See also:
Reporting Safety Defects to the United States Government
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addi ...
Tire and Loading Information Label
A vehicle-specific Tire and Loading Information label is attached to the vehicle's center pillar (B-pillar).
With the driver door open, you will find the label attached below the door lock post.
T ...
Dome light
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at its ends are aligned vertically.
3. Pull the bulb straight downward to ...