Subaru Legacy: Compass zone adjustment
Compass calibration zones
1. Refer to the “Compass calibration zones” map shown above to verify that the
compass zone setting is correct for your geographical location.
2. Press and hold the switch for 6 seconds until the zone selection comes up (a
number will be displayed in the mirror compass window).
3. Press the switch repeatedly until the correct zone setting for your location
is displayed.
4. Releasing the button for 10 seconds will exit the zone setting mode.
Photosensors
The mirror has a photosensor attached on the front and back sides. During nighttime driving, these sensors detect distracting glare from vehicle headlights behind you and automatically dim the m ...Compass calibration
1. If a “C” is displayed in the compass window, the compass needs to be calibrated. 2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads a direction. 3. You can a ...See also:
Shift Lever Position Indicators
These indicators on the instrument
panel show which position the shift
lever is in.
Using a paddle shift mode, the gear
position indicator shows you the
selected gear number.
The ‘‘D ...
Supplemental Restraint System Components
The supplemental restraint systems (SRS) have two basic subsystems:
- The air bag system with inflators and air bags.
- The electrical system with crash sensors and diagnostic module.
The air bags ...
Antenna
Window antenna
The antenna pattern is printed inside the rear window.
CAUTION:
- Do not place metalized film near the rear window glass or attach any metal
parts to it. This may cause poor recept ...