Buick LaCrosse: Cruise Control
With cruise control, the vehicle can maintain a speed of about 40 km/h (25 mph) or more without keeping your foot on the accelerator. Cruise control does not work at speeds below 40 km/h (25 mph).
On vehicles with the Traction Control System (TCS) or the StabiliTrak® system, it may begin to limit wheel spin while you are using cruise control. If this happens, the cruise control will automatically disengage. See Traction Control System (TCS) or StabiliTrak® System.
WARNING!
Cruise control can be dangerous
where you cannot drive safely at
a steady speed. So, do not use
the cruise control on winding
roads or in heavy traffic.
Cruise control can be dangerous
on slippery roads. On such roads,
fast changes in tire traction can
cause excessive wheel slip, and
you could lose control. Do not use
cruise control on slippery roads.
The cruise control buttons are located on the steering wheel.
(On/Off): Press to turn the cruise control system on and off. An indicator light will turn on or off in the instrument panel cluster.
(Cancel): Press to disengage cruise control without erasing the set speed from memory.
RES/+ (Resume/Accelerate):
Move the thumbwheel up to make the vehicle resume to a previously set speed or to accelerate.
SET/− (Set/Coast): Move the thumbwheel down to set the speed and activate cruise control or make the vehicle decelerate.
- Setting Cruise Control
- Resuming a Set Speed
- Increasing Speed While Using Cruise Control
- Reducing Speed While Using Cruise Control
- Passing Another Vehicle While Using Cruise Control
- Using Cruise Control on Hills
- Ending Cruise Control
- Erasing Speed Memory
Selective Ride Control
The vehicle may have a ride control system called Selective Ride Control. The system provides the following performance benefits: • Reduced Impact Harshness • Improved Road Isolation • ...Setting Cruise Control
If the cruise button is on when not in use, it could get bumped and go into cruise when not desired. Keep the cruise control switch off when cruise is not being used. 1. Press to turn the cr ...See also:
Engine compartment fuse replacement
1. Turn the ignition switch and all other switches off.
2. Remove the fuse panel cover by pressing the tab and pulling up.
3. Check the removed fuse; replace it if it is blown. To remove or insert ...
Vehicle security system activation
The vehicle security system will give the following
alarm:
● The headlights blink and the horn sounds
intermittently.
● The alarm automatically turns off after approximately
50 second ...
Setting the Time and Date
(With Date Display)
1. Press the CONFIG button and
select Time and Date Settings,
or press .
2. Select Set Time or Set Date.
3. Turn the Menu knob to adjust
the highlighted value.
4. Press SELECT to select the n ...