Subaru Legacy: Cruise control indicator light
The cruise control indicator light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 3 seconds.
This light illuminates when the “CRUISE” main switch is pressed.
NOTE
● If you press the main switch button while turning the ignition switch “ON”, the cruise control function is deactivated and the “CRUISE” indicator light flashes. To reactivate the cruise control function, turn the ignition switch back to the “Acc” or “LOCK” position, and then turn it again to the “ON” position.
● If this indicator light and the CHECK ENGINE warning light/malfunction indicator lamp flash simultaneously during driving, have the vehicle checked by your nearest SUBARU dealer.
High beam indicator light
This light shows that the headlights are in the high beam mode. This indicator light also illuminates when the headlight flasher is operated. ...Cruise control set indicator light
The cruise control set indicator light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 3 seconds. This light illuminates when vehicle spe ...See also:
Services Not Included in
Roadside Assistance
• Impound towing caused by
violation of any laws.
• Legal fines.
• Mounting, dismounting,
or changing of snow tires,
chains, or other traction devices.
• Towing or services for vehicl ...
Selection Of Lubricant
It is important that the proper lubricant is used in the
transmission to assure optimum transmission performance.
Use only the manufacturer’s recommended transmission
fluid. Refer to “Fluids, ...
Automatic mode
The automatic engine start/stop function is operational
after each engine start.
The function is activated above a certain speed.
▷ Manual transmission: above 3 mph, approx.
5 km/h.
▷ ...