Chrysler 200: Customer Key Programming
You can program new keys to the system if you have two valid Sentry Keys by performing the following procedure:
1. Cut the additional Sentry Key Transponder blank(s) to match the ignition switch lock cylinder key code.
2. Insert the first valid key into the ignition switch. Turn the ignition switch to the ON/RUN position for at least three seconds, but no longer than 15 seconds. Then, turn the ignition switch to the LOCK position and remove the first key.
3. Insert the second valid key into the ignition switch.
Turn the ignition switch to the ON/RUN position within 15 seconds. After ten seconds, a chime will sound. In addition, the Vehicle Security Light will begin to flash.
Turn the ignition switch to the LOCK position and remove the second key.
4. Insert a blank Sentry Key into the ignition switch.
Turn the ignition switch to the ON/RUN position within 60 seconds. After 10 seconds, a single chime will sound.
In addition, the Vehicle Security Light will stop flashing.
To indicate that programming is complete, the indicator light will turn on again for three seconds and then turn off.
The new Sentry Key is programmed. The Remote Keyless Entry (RKE) transmitter will also be programmed during this procedure.
Repeat this procedure to program up to eight keys. If you do not have a programmed Sentry Key contact your authorized dealer for details.
NOTE:
If a programmed key is lost, see your authorized
dealer to have all remaining keys erased from the systems
memory. This will prevent the lost key from starting
your vehicle. The remaining keys must then be reprogrammed.
All vehicle keys must be taken to your authorized dealer at the time of service to be reprogrammed.
Replacement Keys
NOTE: Only keys that have been programmed to the vehicle electronics can be used to start the vehicle. Once a Sentry Key has been programmed to a vehicle, it cannot be programmed to any other v ...General Information
The Sentry Key system complies with FCC rules part 15 and with RSS-210 of Industry Canada. Operation is subject to the following conditions: • This device may not cause harmful interference. ...See also:
Emergency trunk safety release
Your vehicle is equipped with an emergency trunk release cable located inside
the trunk. The lever glows in the dark when the trunk lid is closed. If someone
is inadvertently locked in the trunk ...
Warranty information
See the Warranty Information Booklet, located on theDVD, for the terms and provisions
of Chrysler GroupLLC warranties applicable to this vehicle and market. ...
Remote Lock/Unlock/Start
Select Remote Lock/Unlock/Start
and the following will be displayed:
• Unlock Feedback (Lights)
• Locking Feedback
• Door Unlock Options
• Remote Recall
• Passive Entry
• Remote Le ...