Subaru Legacy: Daytime running light system
WARNING
The brightness of the illumination of the high beam headlights is reduced by
the daytime running light system. The light switch must always be turned to the
“
” position when it is dark outside.
The high beam headlights will automatically illuminate at reduced brightness when the engine has started, under the following conditions.
● The parking brake is fully released.
● The light switch is in the “OFF” or “ ” position.
● The light switch is in the “AUTO” position and the headlights do not turn on automatically.
● The select lever is in a position other than the “P” position (AT and CVT models).
NOTE
When the light switch is in the “ ” position, the front side marker lights, tail lights and license plate lights are illuminated.
Headlight flasher
CAUTION
Do not hold the lever in the flashing position for more than just a few seconds.
To flash the headlights, pull the lever toward you and then release it. The high
beam will stay on for as ...
Turn signal lever
To activate the right turn signal, push the turn signal lever up. To activate
the left turn signal, push the turn signal lever down. When the turn is finished,
the lever will return automaticall ...
See also:
Hoses
Hoses transport fluids and should
be regularly inspected to ensure
that there are no cracks or leaks.
With a multi-point inspection, your
dealer can inspect the hoses and
advise if replacemen ...
Manual Transmission (if so equipped)
● Always tow with the manual transmission in
Neutral.
● After towing 500 miles (805 km), start and
idle the engine with the transmission in Neutral
for two minutes. Failure to idle the ...
Tire And Loading Information Placard Location
NOTE:
The proper cold tire inflation pressure is listed
on the driver’s side B-Pillar or the rear edge of the
driver’s side door.
Tire Placard Location ...
