BMW 5 Series: Deactivating DSC: DSC OFF
When DSC is deactivated, driving stability is reduced during acceleration and when driving in bends.
Stabilizing interventions by the Integral Active Steering system are only performed by the rear axle steering.
To increase vehicle stability, activate DSC again as soon as possible.
Deactivating DSC
Press and hold the button, but not longer than approx. 10 seconds, until the indicator lamp for DSC lights up in the instrument cluster and DSC OFF is displayed.
The DSC system is switched off.
Activating DSC
Press the button.
DSC OFF and the DSC indicator lamp go out.
Indicator/warning lamps
When DSC is deactivated, DSC OFF is displayed in the instrument cluster.
The indicator lamp lights up: DSC is deactivated.
Indicator/warning lamps
The indicator lamp flashes: DSC controls the drive forces and brake forces. The indicator lamp lights up: DSC has failed. ...See also:
Using the information button
1. Press the information button
2. All of the indicator lights will flash sequentially for approximately 7 seconds
to indicate that the PCC is receiving information from the vehicle. If any of the ...
Most common factors contributing to vehicle
corrosion
● The accumulation of moisture-retaining dirt
and debris in body panel sections, cavities,
and other areas.
● Damage to paint and other protective coatings
caused by gravel and stone c ...
Attaching the towing eyelet
The towing eyelet is located under the floor of the trunk. This eyelet must
be screwed into the positions provided on the right sides of either the front
or rear bumper (see illustration).
...