Mercedes-Benz E-Class: Deactivating the HOLD function - HOLD function - Driving systems - Driving and parking - Mercedes-Benz E-Class Owners ManualMercedes-Benz E-Class: Deactivating the HOLD function

The HOLD function is deactivated automatically if:

 - you accelerate and the transmission is in position D or R.
 - you shift the transmission to position P.
 - you apply the brakes again with a certain amount of pressure until HOLD disappears from the multifunction display.
 - you activate DISTRONIC PLUS.

WARNING
Never get out of the vehicle when the HOLD function is activated.

The HOLD function must never be operated or deactivated by a passenger or from outside the vehicle.

The HOLD function does not replace the parking brake and must not be used for parking.

The braking effect of the HOLD function is canceled and the vehicle could roll away if:

 - the HOLD function is deactivated by depressing the accelerator pedal or the brake pedal.

 - there is a malfunction in the system or an interruption in the power supply, e.g.

battery failure.

 - the electrical system in the engine compartment, the battery or the fuses are tampered with.

 - the battery is disconnected.

If you leave the vehicle or park it, deactivate the HOLD function and secure the vehicle against rolling away.

When the HOLD function is activated, the transmission is shifted automatically to position P if:

 - the driver's door is open and the driver's seat belt is unfastened.
 - the engine is switched off.
 - the hood is opened.
 - a system malfunction occurs.
 - the power supply is not sufficient.

If the engine has been switched off, it cannot be started again until the HOLD function has been deactivated.

If there is a malfunction in the system or power supply while the HOLD function is activated, the Brake immediately message is shown in the multifunction display.

Immediately depress the brake firmly until the warning message in the multifunction display goes out.

    Activating the HOLD function
    •► Make sure that the activation conditions are met. •► Depress the brake pedal. •► Quickly depress the brake pedal further until HOLD display 1 appears in the multif ...

    See also:

    Check the fluid level monthly.
    1. Drive the vehicle several miles to raise the temperature of the transmission fluid up to normal operating temperature; 158 to 1768F (70 to 808C) is normal. 2. Park the vehicle on a level surface ...

    Securing Child Restraints (Front Passenger Seat)
    This vehicle has airbags. A rear seat is a safer place to secure a forward-facing child restraint. See Where to Put the Restraint. In addition, the vehicle has a passenger sensing system whic ...

    Non-recommendation of the use of gasoline containing MMT
    Some gasoline contains an octane enhancing additive called MMT (Methylcyclopentadienyl Manganese Tricarbonyl). Toyota does not recommend the use of gasoline that contains MMT. If fuel containin ...