Volvo S60: Detachable trailer hitch (accessory)
A - Ball holder
B - Locking bolt
C - Cotter pin
D - Hitch assembly
E
- Safety wire attachment
Installing the ball holder
1. If necessary, remove the cotter pin from the locking bolt and slide the locking bolt out of the hitch assembly.
2. Slide the ball holder into the hitch assembly.
3. Align the hole in the ball holder with the one in the hitch assembly.
4. Slide the locking bolt through the hitch assembly/ball holder.
5. Insert the cotter pin in the hole at the end of the locking bolt.
Removing the ball holder
1. Remove the cotter pin from the locking bolt and slide the locking bolt out of the ball holder/hitch assembly.
2. Pull the ball holder out of the hitch assembly.
NOTE
A cover for the hitch assembly is also included in the kit.
Introduction
Volvo recommends the use of Volvo trailer hitches that are specially designed
for the vehicle.
NOTE
See page 337 for the maximum trailer and tongue weights recommended by Volvo.
Observe t ...
Trailer Stability Assist (TSA)
Trailer Stability Assist is a system designed to help stabilize a vehicle that
is towing a trailer when the vehicle and trailer have begun to sway and is part
of the Dynamic Stability and Traction ...
See also:
Total trailer weight
Total trailer weight
The total trailer weight (trailer weight plus its cargo load) must never exceed
the maximum weight.
Legacy
The total trailer weight must not exceed 1,000 lbs (453 kg).
Out ...
Keys
1. Two Intelligent Keys
2. Mechanical keys (inside Intelligent
Keys)
3. Key number plate ...
Lane Change Assist
Tap the lever up or down once, without moving beyond
the detent, and the turn signal (right or left) will flash
three times then automatically turn off. ...
