Ford Fusion: Disabling the passenger airbag - Occupant protection - Ford Fusion Owners manualFord Fusion: Disabling the passenger airbag

WARNING:

Make sure that the passengerairbag is disabled when using arearward facing child restraint on thefront passenger seat.

Fitting the passenger airbagdeactivation switch

Fitting the passenger airbagdeactivation switch

WARNING:

If you need to fit a child restraint ona seat protected by an operationalairbag in front of it, have apassenger airbag deactivation switchfitted. Ask your dealer for furtherinformation.

Note: The key switch is located in theglove compartment with an airbagdeactivation lamp in the instrument panel.

If the airbag warning lamp illuminates orflashes when you are driving, this indicatesa malfunction. See Warning lamps andindicators. Remove the childrestraint and have the system checkedimmediately.

Turn the switch to position A.

Disabling the passenger airbagDisabled AEnabled B

Turn the switch to position A.

When you switch the ignition on, checkthat the passenger airbag deactivationwarning lamp illuminates.

Enabling the passenger airbag

WARNING:

Make sure that the passengerairbag is enabled when you are notusing a child restraint on the frontpassenger seat.

Turn the switch to position B.

    Using seat belts during pregnancy
    Using seat belts during pregnancy WARNING: Position the seat belt correctly foryour safety and that of your unbornchild. Do not use only the lap strapor the shoulder strap. Position the lap strap c ...

    See also:

    Winter driving
    More severe weather conditions of winter result in greater wear and other problems. To minimize winter driving problem, you should follow these suggestions: Snowy or icy conditions To drive your ...

    Removing and installing the clips
    The luggage trim cover and trunk panel cover clip Removing Installing The fender liner clip Installing CAUTION ■Replacing light bulbs ●Turn off the lights. Do not attempt ...

    Starting the engine
    Check that the parking brake is set. Check that the shift lever is set in P. If the shift lever is not set in P, the engine may not be started. Firmly depress the brake pedal. The smart key ...