Subaru Legacy: Driver’s seat
1) Seat position forward/backward control switch
To adjust the seat forward or backward, move the control switch forward or backward.
During forward/backward adjustment of the seat, you cannot adjust the seat cushion
angle or seat cushion height.
2) Seat cushion angle control switch
To adjust the seat cushion angle, pull up or push down the front end of the control
switch.
3) Seatback angle (reclining) control switch
To adjust the angle of the seatback, move the control switch.
4) Seat height control switch
To adjust the seat height, pull up or push down the rear end of the control switch.
5) Lumbar support control switch
To increase lower back support, push the front side of the switch. To decrease lower
back support, push the rear side of the switch.
Power seat (if equipped)
WARNING To prevent the passenger from sliding under the seatbelt in the event of a collision, always put the seatback in the upright position while the vehicle is in motion. Also, do not place ...Front passenger’s seat (if equipped)
1) Seat position forward/backward control switch To adjust the seat forward or backward, move the control switch forward or backward. 2) Seatback angle (reclining) control switch To adjust the an ...See also:
Gross Axle Weight (GAW) and Gross Axle Weight Rating (GAWR)
Gross Axle Weight
The total weight applied to each axle (GAW) must never exceed the Gross Axle
Weight Rating (GAWR). The front and rear GAWs can be adjusted by relocating passengers
and luggage ...
Checking the fluid level when the fluid is cold
When the fluid level has to be checked without time to warm up the automatic
transmission, check to see that the fluid level is between the lower level and upper
level on the “COLD” range. If ...
Turn signal switch
Turn signal
(1) Move the lever up or down to signal the turning direction. When the turn
is completed, the turn signals cancel automatically.
Lane change signal
(2)- To signal a lane change ...