Chrysler 200: Elapsed Time
Shows the total elapsed time of travel since the last reset.
Elapsed time will increment when the ignition switch is in the RUN or START position.
Elapsed time is displayed as follows:
hours:minutes:seconds
Elapsed time can be reset by pressing and holding the SELECT button (as prompted in the EVIC display). Upon reset all digits will change to zeros and time will start incrementing again if the ignition switch is in RUN or START.
Tire Psi
Press and release the MENU button until Tire PSI is displayed. Tire pressure information is displayed as follows: • If tire pressure is OK for all tires, TIRE and a vehicle graphic are display ...EVIC Units Selection (Units In Display)
Displays the units used for the Outside Temperature, Average Fuel Economy, Distance to Empty and Tire Pressure features. Press and Release the SELECT button to toggle units between U.S. and METR ...See also:
Pulling off the fender lining
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the eng ...
System maintenance
NOTE
In the event that the vehicle’s battery is replaced, discharged or disconnected,
it will be necessary to start the vehicle a minimum of one time using the key prior
to activating the remot ...
Drive shafts and boots
Check the drive shafts, boots and clamps for cracks, deterioration, or damage.
Replace any damaged parts and, if necessary, repack the grease. ...